Hi,
I have install SONiC on my Mellanox SN2010 switch. But I canno't see the information provided by the command show interfaces transceiver eeprom
Thi is my SONiC version:
Current: SONiC-OS-master.424-f61ff95e
Next: SONiC-OS-master.424-f61ff95e
Available:
SONiC-OS-master.424-f61ff95e
When I use the command show interfaces transceiver eeprom Ethernet0 --dom I get this error:
Usage: show interfaces transceiver eeprom [OPTIONS] [INTERFACENAME]
Try "show interfaces transceiver eeprom -h" for help.
Error: cannot find interface name for alias Ethernet0
If I use the command show interfaces alias:
Name Alias
---------- ----------
Ethernet0 Ethernet0
And the command -d /dev/mst/mt52100_pci_cr0 -p 1 --show_serdes_tx show:
Operational Info
----------------
State : Active
Physical state : LinkUp
Speed : 10GbE
Width : 1x
FEC : No FEC
Loopback Mode : No Loopback
Auto Negotiation : ON
Supported Info
--------------
Enabled Link Speed : 0x00007010 (10G)
Supported Cable Speed : 0x3c007011 (25G,10G,1G)
Troubleshooting Info
--------------------
Status Opcode : 0
Group Opcode : N/A
Recommendation : No issue was observed.
Serdes Tuning Transmitter Info
------------------------------
Serdes TX parameters : Pol,tap0,tap1,tap2,bias,preemp_mode
Lane 0 : 0,0,120,0,16,4
What I'm doing wrong? Why the SFP EEPROM is not detected ?
Hi,
I have install SONiC on my Mellanox SN2010 switch. But I canno't see the information provided by the command
show interfaces transceiver eepromThi is my SONiC version:
When I use the command
show interfaces transceiver eeprom Ethernet0 --domI get this error:If I use the command
show interfaces alias:And the command
-d /dev/mst/mt52100_pci_cr0 -p 1 --show_serdes_txshow:What I'm doing wrong? Why the SFP EEPROM is not detected ?