Marlin 1.0.0b1 and netfabb?

[jgeerds-zz]

Just a quick question: is Marlin 1.0.0b1 supposed to be compatible with netfabb?
A quick test resulted in either super slow XY movements, or pretty fast movements (2 different profiles), but both of them had the extruder spinning like mad... if it's supposed to work with netfabb, does this mean everything needs to be re-calibrated to about 5% of the original RPM? (it felt like the extruder was running 20x too fast)

[bkubicek]

I have printed using it and Netfabb's direct print. The only thing that you need to do is to add the M92 E14 in the start gcode, if you have an ultimaker. Thats because Netfabb is no outputing volumetric E-values that are compatible with netfabb>40.
We have asked Alexander one month ago, to chnage this in netfabb, and he did not give a real answer weather he would do it.
But M92 E14 fixes it, for different printer models use M92 E<the e_steps_per_mm you used with skeinforge 3*>

[ErikZalm]

Hello,

Netfabb expects a e-steps value around 14. Then you can calibrate.
You can set it with M92 E14

Best regards,

Erik van der Zalm

----- Original Message -----
From: "jgeerds" reply@reply.github.com
To: "ErikZalm" erik@vdzalm.eu
Sent: Tuesday, November 22, 2011 5:07:19 AM
Subject: [Marlin] Marlin 1.0.0b1 and netfabb? (#14)

Just a quick question: is Marlin 1.0.0b1 supposed to be compatible with netfabb?
A quick test resulted in either super slow XY movements, or pretty fast movements (2 different profiles), but both of them had the extruder spinning like mad... if it's supposed to work with netfabb, does this mean everything needs to be re-calibrated to about 5% of the original RPM? (it felt like the extruder was running 20x too fast)

---

Reply to this email directly or view it on GitHub:
https://github.com/ErikZalm/Marlin/issues/14

[github-actions]

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.