🔧 Config updates

Author: thinkyhead

Marlin/Configuration.h

@@ -82,7 +82,7 @@ preheat_1_temp_hotend                    = 180
 bang_max                                 = 255
 pidtemp                                  = on
 pid_k1                                   = 0.95
-pid_max                                  = BANG_MAX
+pid_max                                  = 255
 pid_functional_range                     = 10
 
 default_kp                               = 22.20
@@ -140,10 +140,10 @@ invert_x_step_pin                        = false
 invert_y_step_pin                        = false
 invert_z_step_pin                        = false
 
-disable_x                                = false
-disable_y                                = false
-disable_z                                = false
-disable_e                                = false
+disable_x                                = off
+disable_y                                = off
+disable_z                                = off
+disable_e                                = off
 
 proportional_font_ratio                  = 1.0
 default_nominal_filament_dia             = 1.75

Marlin/Configuration_adv.h

@@ -33,13 +33,13 @@
  * Check for common serial pin conflicts
  */
 #define CHECK_SERIAL_PIN(N) ( \
-     X_STOP_PIN == N || Y_STOP_PIN == N || Z_STOP_PIN == N \
-  || X_MIN_PIN  == N || Y_MIN_PIN  == N || Z_MIN_PIN  == N \
-  || X_MAX_PIN  == N || Y_MAX_PIN  == N || Z_MAX_PIN  == N \
-  || X_STEP_PIN == N || Y_STEP_PIN == N || Z_STEP_PIN == N \
-  || X_DIR_PIN  == N || Y_DIR_PIN  == N || Z_DIR_PIN  == N \
-  || X_ENA_PIN  == N || Y_ENA_PIN  == N || Z_ENA_PIN  == N \
-  || BTN_EN1    == N || BTN_EN2    == N \
+     X_STOP_PIN == N || Y_STOP_PIN == N || Z_STOP_PIN  == N \
+  || X_MIN_PIN  == N || Y_MIN_PIN  == N || Z_MIN_PIN   == N \
+  || X_MAX_PIN  == N || Y_MAX_PIN  == N || Z_MAX_PIN   == N \
+  || X_STEP_PIN == N || Y_STEP_PIN == N || Z_STEP_PIN  == N \
+  || X_DIR_PIN  == N || Y_DIR_PIN  == N || Z_DIR_PIN   == N \
+  || X_ENA_PIN  == N || Y_ENA_PIN  == N || Z_ENA_PIN   == N \
+  || BTN_EN1    == N || BTN_EN2    == N || LCD_PINS_EN == N \
 )
 #if SERIAL_IN_USE(0)
   // D0-D1. No known conflicts.